Redstone Port

The Redstone Port allows you to automate your Turbine using Redstone.

Open the Port graphical interface to configure it. You can then choose between three input settings (that listen for a Redstone signal) and four output ones (that emit a Redstone signal).

Input settings

Perform one of the following actions when a Redstone signal is received


• On / Off : turn the Turbine on or off depending on the signal received
• Induction Coils : engage or disengage the induction coils
• Flow Rate : change the maximum flow rate of vapor inside the Turbine.

Output settings

Emit a Redstone signal when one of the following conditions are meet


• Rotor Speed : the speed of the Turbine rotor is above, below or in between a given value
• Coolant amount : the amount of coolant in the Turbine is above, below or in between a given value
• Vapor amount : the amount of vapor in the Turbine is above, below or in between a given value

• Energy Stored : the amount of energy stored in the internal energy buffer is above, below or in between a given value.

You will usually need two or more Redstone Port to fully automate a Turbine.

For more complex automations, check the Computer Port.

Mandatory: no
Valid positions: any face (not on frame)
Variants: all
Graphical interface: yes