Порт ресурсов реактора

Reactor Resource Port Attach Reactor Resource Port(s) to the casing to move items and/or fluids between the outside world and the reactor. Typical layouts Manual / RF-only (no ports required) Fuel and waste can be handled through the Reactor Controller GUI. You still need at least one Power Port. Automation: fuel in + waste out (two ports, same face as controller) Put both resource ports on the same wall as the reactor controller. Example in Getting started — ports are spread on that face; hover the diamonds in the scene for setup hints. Port (example) Mode Filter Moves Lower-left INSERT Fuel Solid fuel into rods Lower-right EXTRACT Waste Waste out Add a power port on that same face. Pipe/hopper on the outside of each port. Fluid coolant loop (extra ports, optional) If you run active coolant (Setup 2 in Getting started): INSERT with Coolant filter — pipe coolant in (Import: coolant fluid only.) EXTRACT with Coolant filter — pipe steam / spent fluid out → Turbine Getting started (Output: exhausted liquid coolant only.) Keep EXTRACT waste on a separate port; do not expect one EXTRACT p…

Getting started — your first reactor Build a closed reactor shell, then pick one of the two setups below. Rotate the scene to inspect each face. Shell layout Floor and roof: Reactor Casing (closed frame). Vertical corners: Reactor Casing pillars at the four edges (y=1…5). West, east, and south walls: 5×5 Reactor Glass panel on each face (five rows × five columns between the corner pillars). Controller face (north in the example): the Reactor Controller protrudes outward as a single block; remaining cells on that face use Reactor Glass where no port is placed. Ports replace glass on that wall — same idea as on the other faces, not a bare open frame. Ports: on the same wall as the controller — they can sit anywhere on that face (the example spreads them away from the controller on purpose). The Reactor Builder places casing, glass (if in buffer), rods, and heat sinks — not the controller or ports. Heat sinks vs coolant These are two different systems: Heat sinks (passive) Coolant (active) What Blocks or stationary liquid fill inside the shell next to rods Working fluid in the controlle…