Конструктор реактора

Reactor Builder The Reactor Builder places the reactor interior and shell from materials in its buffer and tank. It does not place the Reactor Controller, power ports, or resource ports — see Getting started. What Build places (in order) Casing shell (optionally open top for later edits) Rod controllers on the top layer above each rod column Reactor rods in the interior pattern Fluid heat sinks (1000 mB per cell) when configured Solid heat sink blocks in remaining interior cells Typical workflow Place the builder against the intended footprint (orientation matters). Open the GUI: set size, rod pattern, pattern mode, heat sink type, and open top if needed. Preview — purple border, yellow rod positions, red = invalid/extra blocks. Mark input — assign buffer slots to specific items (see button tooltips). Build when the buffer/tank hold enough materials; Stop if red zones appear or you need to edit. Remove or ignore the builder block — it is not part of the multiblock. Manually add controller, power port, and resource port(s) after the build — controller outside one wall; ports on that s…

Getting started — your first reactor Build a closed reactor shell, then pick one of the two setups below. Rotate the scene to inspect each face. Shell layout Floor and roof: Reactor Casing (closed frame). Vertical corners: Reactor Casing pillars at the four edges (y=1…5). West, east, and south walls: 5×5 Reactor Glass panel on each face (five rows × five columns between the corner pillars). Controller face (north in the example): the Reactor Controller protrudes outward as a single block; remaining cells on that face use Reactor Glass where no port is placed. Ports replace glass on that wall — same idea as on the other faces, not a bare open frame. Ports: on the same wall as the controller — they can sit anywhere on that face (the example spreads them away from the controller on purpose). The Reactor Builder places casing, glass (if in buffer), rods, and heat sinks — not the controller or ports. Heat sinks vs coolant These are two different systems: Heat sinks (passive) Coolant (active) What Blocks or stationary liquid fill inside the shell next to rods Working fluid in the controlle…