Секвенсор

The Sequencer is a versatile block that can generate specific sequences of redstone signal based on other redstone inputs. It works by selecting 64 different redstone outputs. Whenever a sequence runs it will set the redstone output of this block to this pattern in sequence

There are 7 different modes:

• Once1: Cycle once. Ignores signals until done
• Once2: Cycle once. Restart cycle on new signal
• Loop1: Continuous loop. Ignore redstone signals
• Loop2: Continious loop. Signal resets cycle to start
• Loop3: Continious loop while enabled. Stay at current step if disabled
• Loop4: Continious loop while enabled. Reset to beginning if disabled
• Step: Perform one step in the cycle on every signal