Герметичный люк (Pressure Hatch) — как скрафтить в Nautec 2 | Вики PiglinMine
Герметичный люк
Блоки · Nautec 2

Герметичный люк

Pressure Hatch
СборкаРецепты ниже — для мода без изменений

Герметичный люк — блок из мода Nautec 2.

Как работает #how

Из книги «NauTec 2 — руководство» — Underwater Bases[1]

Underwater Bases

Blocks for a dry, permanent base on the sea floor.

Clear the space first with a Bubble Anchor, wall it in, and set the anchor to leave air when it ends. These blocks keep the room dry afterwards.


Pressure Hatch

A steel door with a porthole, two blocks tall. Open and close it by hand or with redstone.

  • The sea never comes through it, open or closed, so you can swim in through an open hatch and the room behind it stays dry.
  • Every time it closes it pumps out the water on both sides of it, as long as that water is a small pocket: the water you dragged in, a flooded doorway, a leak. Up to 64 blocks of connected water are cleared at once.
  • Water that is part of the sea, or a flooded room bigger than 64 blocks, is left alone, so closing a hatch never drains the ocean outside.

Placing a hatch in water clears the two blocks it fills, so you can fit one straight into a flooded doorway.

Мод не переведён — текст книги на английском, как в игре.

Читать запись целиком

Получение #obtain

Делают по 1 рецепту: верстак.[2]

Источники

  1. Встроенная книга «NauTec 2 — руководство», запись «Underwater Bases»
  2. Рецепты из jar модов без изменений сборок