Конструктор турбины

Turbine Builder The Turbine Builder builds the turbine for you from items in its inventory—similar to the Reactor Builder. Typical workflow Place the builder on the face where you want the turbine shell to start. Open the screen and set width, height, and depth (within your pack’s size limit). Stock the builder with casing, glass, rod controller, rods, blades, and the storage blocks you want for coils. Pick a layout: Efficient — fewer rod columns (checkerboard); blades grow ring by ring up the shaft (+3% height bonus possible—see Rods and blades). Productive — rods on every allowed column; each layer gets full rings right away (maximum steam sooner). Choose coil type (cycles the metals the mod supports) and how many coil layers (default 3, change with ◀ ▶ on screen). Use preview and the simulation panel to see estimated RF/t, steam use, and materials needed. Mark input tells the builder which inventory slots supply which blocks for each step. Press Build when ready. You can add fluid to the builder tank if your pack uses that for setup checks. Build order: outer shell → rod controlle…

Getting started — your first turbine Build a closed turbine shell with a rotor and coils inside, then pick one of the two setups below. Rotate the scene to inspect each face. Shell layout Floor and roof: Turbine Casing (closed frame). Vertical corners: Turbine Casing pillars at the four edges (y=1…5). West, east, and south walls: 5×5 Turbine Glass panel on each face. Divider wall at rod-controller height (y=3 in the example): Turbine Casing ring inside and casing band on the side walls — this row cuts through the 5×5 glass on those three faces. Controller face (north in the example): the Turbine Controller protrudes outward as a single block; remaining cells on that face use Turbine Glass where no port is placed. Ports replace glass on that wall — same layout as the reactor example. Coil zone (above the divider): two layers at the top of the interior (y=4–5 in the example) — copper blocks directly under the roof casing. Rotor zone (below the divider): two rod segments (y=1–2) — four blades on the lower ring, eight blades in two rings on the upper segment; Turbine Rod Controller sits …