Лопасть турбины

Getting started — your first turbine Build a closed turbine shell with a rotor and coils inside, then pick one of the two setups below. Rotate the scene to inspect each face. Shell layout Floor and roof: Turbine Casing (closed frame). Vertical corners: Turbine Casing pillars at the four edges (y=1…5). West, east, and south walls: 5×5 Turbine Glass panel on each face. Divider wall at rod-controller height (y=3 in the example): Turbine Casing ring inside and casing band on the side walls — this row cuts through the 5×5 glass on those three faces. Controller face (north in the example): the Turbine Controller protrudes outward as a single block; remaining cells on that face use Turbine Glass where no port is placed. Ports replace glass on that wall — same layout as the reactor example. Coil zone (above the divider): two layers at the top of the interior (y=4–5 in the example) — copper blocks directly under the roof casing. Rotor zone (below the divider): two rod segments (y=1–2) — four blades on the lower ring, eight blades in two rings on the upper segment; Turbine Rod Controller sits …

Rods and blades Placing blades The Turbine Blade is not placed like a normal block. Right-click a Turbine Rod while holding a blade to attach the next blade on that rod. Each click uses one blade from your inventory. Blades grow outward in rings around the rod, kept even on all four sides: First step — 2 blades on opposite sides. Next — 4 blades (one on each side). Then — 8, 12, 16… up to the pack limit (default 31 rings per rod, up to 124 blades on a single rod). The game always picks the side that keeps the layout balanced before moving to the next ring. Blades in the world Blades are ethereal: you cannot walk into them, mine them by hand, or pick them up directly. If you break the rod, every blade on that rod is removed and dropped as items on the rod block—you do not need to search the turbine interior. Blade bonus by height Along the rod controller’s direction, blades are counted per layer (like a floor at each height on a vertical shaft). How layers compare Effect Upper layer has more blades than the one below +3% output bonus per step (pack default) Same blade count No change …